IRA-8095 E-066-0002

[ReproKev]

Replaced the pre-transfer corona and cleaned sensor on back of the filter box with no results.

i searched the forums and found a mention of a tech pub for E-066-0002 but not the actual tech pub. Anyone have the tech pub or other suggestions?

[bobburnsreb]

Re: IRA-8095 E-066-0002

This may be it.

[dan7777]

Re: IRA-8095 E-066-0002

Replaced the pre-transfer corona and cleaned sensor on back of the filter box with no results.

i searched the forums and found a mention of a tech pub for E-066-0002 but not the actual tech pub. Anyone have the tech pub or other suggestions?

I have had that also. The duct gets broken so you can not screw in the fan part, then pre transfer can not reach sensor flag (on part that opens). No need to take all that apart. I have put in two. Only one had code. Tighten those very easy, stop at end. No need to over tighten.

[ReproKev]

Re: IRA-8095 E-066-0002

This may be it.

That's what I was looking for. Thanks.

That didn't take care of the problem though. After closer inspection I found out the pre-transfer cleaning motor wasn't turning at all. It ended up being the wires going into the connector (mounted on the front drum plate area) that the pre-transfer mates to. When I went to pull the connector out of the socket to re-seat it, the wires pulled right out of the connector.

[Liebendeinsam]

Re: IRA-8095 E-066-0002

I have had that also. The duct gets broken so you can not screw in the fan part, then pre transfer can not reach sensor flag (on part that opens). No need to take all that apart. I have put in two. Only one had code. Tighten those very easy, stop at end. No need to over tighten.

What's the sensor for? I have simplified it and now it is permanently "closed". Solved some of the problem.