Coin Op Interface for Canon IRADVC5250

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • RHodg57
    Trusted Tech

    100+ Posts
    • Dec 2013
    • 191
    #1

    Coin Op Interface for Canon IRADVC5250

    I am installing a Jamex 6557B Coin Op to a Canon IRADVC5250 copier. I do not have the instructions for the

    Coin Op Interface PCB however I found the mounting opening for it on the Main Controller 1 face. There is

    only one connector with the correct pin numbers for the interface to connection so I am guessing I have it

    installed correctly. J20 on the Main Controller is where I connected the cable. Just wondered if anyone has

    installed one before I fire it up. Not a very long cable so not many choices for it. Thanks!
    Tags: None
    • copier tech
      Field Supervisor

      5,000+ Posts
      • Jan 2014
      • 8164
      #2
      Re: Coin Op Interface for Canon IRADVC5250

      Originally posted by RHodg57
      I am installing a Jamex 6557B Coin Op to a Canon IRADVC5250 copier. I do not have the instructions for the

      Coin Op Interface PCB however I found the mounting opening for it on the Main Controller 1 face. There is

      only one connector with the correct pin numbers for the interface to connection so I am guessing I have it

      installed correctly. J20 on the Main Controller is where I connected the cable. Just wondered if anyone has

      installed one before I fire it up. Not a very long cable so not many choices for it. Thanks!

      Yes sounds about right, you'll also need to change a couple of settings in service mode enable the coin op unit, you will get an E7xx if not set correctly
      Let us eat, drink, and be merry, because tomorrow we may die!

      For all your firmware & service manual needs please visit us at:

      www.copierfirmware.co.uk - www.printerfirmware.co.uk
      ​

        Comment

        • RHodg57
          Trusted Tech

          100+ Posts
          • Dec 2013
          • 191
          #3
          Re: Coin Op Interface for Canon IRADVC5250

          Originally posted by copier tech
          Yes sounds about right, you'll also need to change a couple of settings in service mode enable the coin op unit, you will get an E7xx if not set correctly

          It's working ...Thanks!!
          Last edited by RHodg57; 12-13-2016, 06:56 PM.

            Comment

            Previous template Next
            Working...