Ir 3025

[bineeshgeorge]

Hai, friends ,what is the reason ? laser unit and drum replaced but no result.

Sent from my HTC Desire X dual sim using Tapatalk

[raman]

Re: Ir 3025

Prints looks wavy from leading to trail edge. Grounding contact on steel registration roller may cause poor contact. Replacement of leaf spring (Part number FC5-1564-000) resolve the problem.

[hitech]

Re: Ir 3025

I recommend lubricating registration roller shaft inside the bushings. Recently had a senior tech show me the same issue, and he said that took care of the problem. Was that LTR or LTRR? If LTRR disregard as my comment wouldn't make sense.

[jper34]

Re: Ir 3025

how about if you run an internal test print...just to eliminate anything in the scanner..

[zoraldinho]

Re: Ir 3025

I have this problem long time ago.If i remember i swap complete right door from another 3025 crap and it's work.Probably grounding issue.

[techandtrader]

Re: Ir 3025

^{Why not the registration clutch?}

[Canuck]

Re: Ir 3025

Remove the ground clip Raman showed. Bias it inward against the roll after cleaning it with sandpaper and applying black conductive grease to it. Never oil it for a squeak. Re-install it. The roll generates electrical noise to the Dcon which controls laser driver. Seen it many times...sometimes machine will log laser errors...E100,E110

[techandtrader]

Re: Ir 3025

thanks for that post. I have found a couple of those making annoying noise due to low grease. Always caught them and lubed them up quick with die electric. That's really wild that clip can do that! : )