Canon ImagePress C7000VP - Installation Assistance Needed

[unwork_inc]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

Thanks for following up - I did review the information provided, which is right on point, and will look into the internal wiring as soon as I have enough time, likely next week at some point

[unwork_inc]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

I just waned to let everyone know that I couldn't look into this issue yet but the information you provided is right on point. Once I have enought time to move my system I'll update this thread. Thank you.

[petermays]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

Power station is attached on main station.Sub station is connected with arcnet and communication cable.
If you wont detach power from main,then must remove all connectors and video cables,
Remove rear panel from power station.
Remove screw from the picture.

[ATTACH=CONFIG]37684[/ATTACH]


Power station dont need to be removed if it's already mounted.Do you have enough power? 3phase,400v, 32 amp?
Check 3 communicaton connectors.they easily change to each other.maybe you've cconnected machine only with one power cable?

in south Africa before we even sell one of these machines a site inspection is done and client needs to put a clean 3 phase power point in.very important.anything less will result in power issue

[Setright]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

Just a simple question: Have you checked your ground connection?

[unwork_inc]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

I'm confident the 3 phase installation is legit. I don't rule out the possibility of some bad internal wiring existing behind the fuse box because it's an old building, but the 3 phase line from the box to the press is clean.
I'll start by making sure the machine is properly connected. If it still doesn't respond, I'll dig deeper down the main powerline.

[Zabia]

Re: Canon ImagePress C7000VP - Installation Assistance Needed

The fiery will say that if the main unit is off - so I think you're okay from that standpoint.

You must have something either connected wrong, or there is a remote signal not getting through the system.

I would check out your power station and confirm the voltages at each board...

You're probably not getting the 12V signal to turn on the DC controller power supply.

Do you have the manual for this badboy? I might have the wiring diagram scanned somewhere if you need it. A bit more tangly than a regular copier lol.

Hey onlyinnewfoundland

I need the wiring diagram. Could you send me? I will install a Canon imagepress c7000vp... Hope Ypu can provide me with that...