I had an error code saying my maint cartridge needed to be replaced.. So I purchased a new one, installed it and turned the printer on.. It went thru its paces and got to the main screen that simply says its model and firmware version (2.15).. Nothing else works, buttons don't do anything.. I tried going into service mode, got the S on the right side of thew screen but still no buttons work.. I can open panels and get the message saying to close it, but thats about it.. Its not connected to a network right now, its in my garage..
The suction comes on and you can hear the ink priming, then stops..
Anyone hear of this issue before?
The suction comes on and you can hear the ink priming, then stops..
Anyone hear of this issue before?