Imagepress c 6010 e0260-2017-05

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • zoraldinho
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Definitely a connector because the machine worked before you ....

    Leave a comment:


  • mc921
    replied
    Re: Imagepress c 6010 e0260-2017-05

    I saw teckats earlier post on the led arrangement for PS diagnostics. It appears all the let's are activated. Still looks like a connector....
    Attached Files

    Leave a comment:


  • zoraldinho
    replied
    Re: Imagepress c 6010 e0260-2017-05

    http://www.copytechnet.com/forums/at...1000-error-pdf

    Leave a comment:


  • zoraldinho
    replied

    Leave a comment:


  • mc921
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Ok...i checked the hopper driver pcb...connections secure...even swapped out the yellow driver with magenta...same code. Checked the yellow drum driver pcb...also swapped with magenta. Same code.

    I'm perplexed because the other than the buffer unit which I Replaced, the machine was working fine. I keep going back to dc controller and an ill fitting connection...but the connections look good. Any other thoughts?

    Thanks again for your assistance.

    Leave a comment:


  • zoraldinho
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Inspect jack no:J1620Y/J1611Y on drum driver pcb and hooper driver pcb jack no:J1420Y/J1410Y


    Good luck

    Leave a comment:


  • mc921
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Cool..ill look into this again. I must gave old manual...nobe of these codes are referenced. Thanks...ill let you know the results.

    Leave a comment:


  • zoraldinho
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Still Hopper driver PCB (Y)

    Leave a comment:


  • mc921
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Ok...i seated all the connections to the yellow hopper...and the code changed. Now the error code is e260-101d-5. 24v issue.

    Leave a comment:


  • zoraldinho
    replied
    Re: Imagepress c 6010 e0260-2017-05

    Did you check for Hopper driver PCB (Y); 13V ?

    Leave a comment:


  • mc921
    started a topic Imagepress c 6010 e0260-2017-05

    Imagepress c 6010 e0260-2017-05

    I had to remove the dc controller assembly to service the waste toner buffer unit. Replaced the buffer with No issue. Now the printer immediately signal error code e0260-2017-05. Power supply issue...

    I have re seated all connectors multiple time with No luck. Anybody have any thoughts?
Working...