canon irc3100 e070-001

[smiley]

hi guys a got this error when i clean the transfer assy. then i think its in the sensor that read the white patch then i change it.the arm support rollers are good.but still the error are not corrected then i change the wire or harnes of itb still no good.then i change the itb but still no good.i clear the error and the dc con.still the error occur.please me...im dont know what to do next.

[Oze]

It's odd that you still have the error AFTER swapping in a new ITB assembly.
In that case I'd be looking at either the cleaning assembly...a new blade can slow the belt down til it's been bedded in properly.
I'm assuming that you cleared the error in service mode?
Failing all that you may have to look at the ITB drive motor....the white patch is not only read but it's also timed....if it it takes the first reading at home position,the DC knows how long it should take for the next pass over the HP sensor...if it takes to long you'll get the HP error(E070)....good luck.

[smiley]

thank oze ill try first the cleaning blade and if not the motor that drives the itb assy.i clear already the error and also the itb i also change the dc but no luck.again thank you soo much.

[Irish]

Dont mean to offend but is the belt back on the right way ??

[11x17]

Also make sure the small black guide is on the outside of the belt and not blocking the HP sensor

[logonjim]

irc3100

the error you are getting is the itb home position is not been detected check all the suggestions also make sure it has the latest software

[smiley]

thanks for the reply guys.the itb get back to its position then it throws the code when it reach the position.can i remove the black thing that blocks the hp sensor?what is the latest firmware you are using?soo that i can request it in canon.please...

[11x17]

The black thing should not be blocking the hp sensor. It needs to go on the outside of the belt.

[smiley]

hello all you guys.thanks for all your reply.the black guid solve the problem it should be outside the belt but some of our 3100 thy located inside and thy work fine.again thank you all.

[Oze]

hello all you guys.thanks for all your reply.the black guid solve the problem it should be outside the belt but some of our 3100 thy located inside and thy work fine.again thank you all.

Good to hear Smiley...
When that black guide is inside the belt IN MOST CASES it causes the belt to rub against the steel plate that sits below the itb cleaning assembly and it can slow the belt down,or, in some cases can tear the belt.

[smiley]

Good to hear Smiley...
When that black guide is inside the belt IN MOST CASES it causes the belt to rub against the steel plate that sits below the itb cleaning assembly and it can slow the belt down,or, in some cases can tear the belt.

thanks oze ill check the black guid in all 3100 itb assy to prevent the damage.im not so trained in this machine im most familiar in 3200 series. 3100 is times 2 harder to do than 3200.thank oze.