Hello,
Anyone had this problem before on a IR-9070?..see attached pics
First 2 prints comes out clean with some background and lines..next what follows comes out total dark background with some double images, the 3 lines on pics 1 & 2 are somehow from the drum stripper fingers.. they match the fingers exactly
Work done so far: replaced all coronas, developer unit, swapped the whole drum assembly but problem stayed..also re seat all connectors on HV board with no change so far
Checked all settings on copier>adjust, all Ok
Anny ideas or help appreciated
Anyone had this problem before on a IR-9070?..see attached pics
First 2 prints comes out clean with some background and lines..next what follows comes out total dark background with some double images, the 3 lines on pics 1 & 2 are somehow from the drum stripper fingers.. they match the fingers exactly
Work done so far: replaced all coronas, developer unit, swapped the whole drum assembly but problem stayed..also re seat all connectors on HV board with no change so far
Checked all settings on copier>adjust, all Ok
Anny ideas or help appreciated