Canon NP 6035F

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Fierhawk
    • Jun 2025
    #1

    Canon NP 6035F

    What would cause the main power switch on this machine to turn itself off after 5 min or less? Any help appreciated, thank you.
    Tags: 6035f, burnt, canon
    • zaza
      MECANOGRAPHE

      1,000+ Posts
      • Mar 2008
      • 1095
      #2
      Originally posted by Fierhawk
      What would cause the main power switch on this machine to turn itself off after 5 min or less? Any help appreciated, thank you.
      ok I answer... you have a short circuit in the machine. try to electrical section for this copier
      BEST TECHNICIAN . NICE PEOPLE .

        Comment

        • 20YRSEXP
          Trusted Tech

          250+ Posts
          • Oct 2008
          • 281
          #3
          The scan lamp will do that. Replace the lamp. is there a code?
          Is the glass half full or half empty? I say neither. The glass is obviously full, full of potential. The potential to hold more water or the potential to quench a thirst. Life is all about how you see it.

            Comment

            • mrfixit51
              Lead Service Technician

              1,000+ Posts
              • Oct 2008
              • 1975
              #4
              Originally posted by Fierhawk
              What would cause the main power switch on this machine to turn itself off after 5 min or less? Any help appreciated, thank you.
              Hello Fierhawk,

              An open circuit, not a short, in either the fuser lamp or doc lamp
              circuits is usually the culprit. Happy hunting!
              "Once a King, always a King, but once a Knight is enough!"

                Comment

                • SteveO
                  #5
                  More times than not it has been the scan lamp. It usually will not give a code.

                    Comment

                    • Canuck
                      Tech Specialist

                      1,000+ Posts
                      • Nov 2007
                      • 1713
                      #6
                      As weird as this sounds...it is the main power switch. I've changed many. If it shuts off right away yeah scanning lamp. If the lamps burnt and hold switch on will give scan lamp error..i think e-220) or e-800. Change the switch

                        Comment

                        • copymon
                          Technician
                          • Feb 2009
                          • 39
                          #7
                          I have had this same problem several times and it was the exp lamp.

                            Comment

                            Previous template Next
                            Working...