Is anyone else having issues with fuser films tearing on the Adv4545/4551 units? We replace a lot of films on different models but seem to be getting a very short life on these models only. I am using compatible films but have been doing so for years without problems. Any help is much appreciated.
-
-
Re: Adv4545 fuser film issues
Used to have issues with the 4000/4200 series blowing a small hole in the center of the film for some reason, and yeah the life was probably getting 50-60% max before it would break....
I don't have a ton of mono stuff left in the field anymore unless its big stuff like 8000 series.
I have a dozen or so 4500/4700/4800 around but no issues with the films yet.
Did you try fw update? there was a firmware for the older units that had to be updated in conjunction with new film installation. -
Re: Adv4545 fuser film issues
I also encountered the same problem and received complaints from customers. But my compatible fixing film supplier told me to pay attention to the following two points：
1、 Worn shaft sleeves need to be replaced
2、 Be sure to apply grease
I'm testing also, and hoping this userful for u~Comment
-
Re: Adv4545 fuser film issues
hi try to replace pressure roller and film at same time. maybe the pressure roller have imbalance pressure that's why its pulling the film in one side and start to tear.there is no glory without sacrifice
Comment
Comment