Clc1180 will not enlarge correctly

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • rlr42173
    Technician
    • Mar 2007
    • 28
    #1

    Clc1180 will not enlarge correctly

    My clc1180 will not enlarge correctly above 175% ratio.

    The scanning lamp will pre-scan and then scan once again, but then the lamp does not move again it just sits there through the 4 color scans and remainder of the job, then the copier will become unresponsive and lock up, so I have to turn it off then back on to be able to use it again.

    I have replaced the scanner board and the scanner motor as well and the ps1 sensor. I am out of ideas on this one short of replacing the dc controller.
    Tags: clc1180, enlarge, unresponsive
    • SCREWTAPE
      • Jun 2025
      #2
      Originally posted by rlr42173
      My clc1180 will not enlarge correctly above 175% ratio.

      The scanning lamp will pre-scan and then scan once again, but then the lamp does not move again it just sits there through the 4 color scans and remainder of the job, then the copier will become unresponsive and lock up, so I have to turn it off then back on to be able to use it again.

      I have replaced the scanner board and the scanner motor as well and the ps1 sensor. I am out of ideas on this one short of replacing the dc controller.
      Are they any recent error codes in the history?

        Comment

        • rlr42173
          Technician
          • Mar 2007
          • 28
          #3
          Any error codes

          The copier is working just fine, except for the not being able to enlarge. Last code was e351-0000

            Comment

            • mrfixit51
              Lead Service Technician

              1,000+ Posts
              • Oct 2008
              • 1975
              #4
              just on the off chance...

              Originally posted by rlr42173
              My clc1180 will not enlarge correctly above 175% ratio.

              The scanning lamp will pre-scan and then scan once again, but then the lamp does not move again it just sits there through the 4 color scans and remainder of the job, then the copier will become unresponsive and lock up, so I have to turn it off then back on to be able to use it again.

              I have replaced the scanner board and the scanner motor as well and the ps1 sensor. I am out of ideas on this one short of replacing the dc controller.
              Have you tried to move the optics all the way to the right of the optics area? 1180's have been around a long time, and you could have some binding occuring in the optics, especially if enlargement is not done very often. Clean and lube the rails, and give it another try.
              "Once a King, always a King, but once a Knight is enough!"

                Comment

                • rlr42173
                  Technician
                  • Mar 2007
                  • 28
                  #5
                  Clc1180 Not enlarging Response

                  Ok I will try that and post the results. Thank You for your prompt response.

                    Comment

                    Previous template Next
                    Working...