IR 3300 E064

[Guest]

I have IR 3300

When i copy/print single side there is no problem

but when i print Back 2 back the Error code E064 problem is there

i have cleaned / replaced both the charging roller but the problem is still there

help me for this

thanx in advance

[Guest]

E64 refers to the HVT.

[davidj7]

replace transfer roll

[bineeshgeorge]

Check the value in develop. or just clear the dc con.

good luck.............

[pinheiro]

Hi,

Check the values in Service Mode and make sure they correspond to the Service Label. If the copier receives a spike or surge through the 240V line these values can change (can also give you blank copies). Take particular note of the Dev Bias setting. [COPIER > ADJUST > DEVELOP > DE-DC]
Make sure the Transport Assembly is engaging properly. The Transfer Roller should make good contact with the drum. Check condition of screw and Pressure Plates for the Transport Assembly.
Clean HVT contacts for Primary/ Transfer Charging Rollers and Developing Assembly. Inspect for any paper clips.
Replace the Transfer Roller.
Replace the Static Charge Eliminator.
Replace Composite Power Supply followed by DC Controller PCB Assembly.

Thanks