imagePROGRAF L Printer Service Tool (Ver. 1.40)_ New

[letstrythisagain]

Re: imagePROGRAF L Printer Service Tool (Ver. 1.40)_ New

============================================
are u connected with a Crossover Cable

are you using the 32bit or 64bit L Printer Tool
see attachments---------------------------------------------

https://www.dropbox.com/s/5l89nl9iph5cnwi/L%20Printer%20Tool___1.80%20Info.pdf?dl=0

https://www.usa.canon.com/internet/portal/us/home/support/details/printers/support-imageprograf-printers/imageprograf-ipf605

Yes I'm connected via crossover cable and am operating on a 64bit. Thank you so much for the attachments, I was finally able to update the firmware to the latest version but to no avail. The "Close Upper Cover" message is still displayed.
Does this sound like it could be my cover switch voltage? Or am I just being too hopeful in thinking I can do anything other than replace the main board?

[teckat]

Re: imagePROGRAF L Printer Service Tool (Ver. 1.40)_ New

Yes I'm connected via crossover cable and am operating on a 64bit. Thank you so much for the attachments, I was finally able to update the firmware to the latest version but to no avail. The "Close Upper Cover" message is still displayed.
Does this sound like it could be my cover switch voltage? Or am I just being too hopeful in thinking I can do anything other than replace the main board?

Have you tested the cover switches

Could ce a power supply issue

[letstrythisagain]

Re: imagePROGRAF L Printer Service Tool (Ver. 1.40)_ New

Have you tested the cover switches

Could ce a power supply issue

Not yet. Any recommendations on proper procedure to isolate my problem?

Thanks in advance

[rodqui6]

Re: imagePROGRAF L Printer Service Tool (Ver. 1.40)_ New

Cry my printer is de

[drbing]

I know the post is out of date, but it happened that my ipf 830 got stuck after a power outage. Replenishing ink,2h all set of inks and waste in trash.The question is, is it possible to overwrite the firmware that is already the latest with the same one? Fut doesn't allow me to do that and I can't find any other tool.