[Misc] IR2525 use ID copy problem

[darkmaster]

Hi, everybody!! Who have see this fault in canon IR2525, that is when i use the ID copy to copy my IC at top and bottom in A4 size but i can get middle black line at the A4 paper.

Then i try to use the function to copy my IC without close the ADF just put the white paper at the top also can get this fault. After that, i use Special features-> image combination -> 2 on 1 -> select A5R -> select A4 to try to merge my IC in the A4 paper also can get same fault!!

somebody can tell me what going on in this new M/C?? Thank You!

[SCREWTAPE]

I would like to help but I have a little trouble understanding what you mean..

[teckat]

Hi, everybody!! Who have see this fault in canon IR2525, that is when i use the ID copy to copy my IC at top and bottom in A4 size but i can get middle black line at the A4 paper.

Then i try to use the function to copy my IC without close the ADF just put the white paper at the top also can get this fault. After that, i use Special features-> image combination -> 2 on 1 -> select A5R -> select A4 to try to merge my IC in the A4 paper also can get same fault!!

somebody can tell me what going on in this new M/C?? Thank You!

iR2525_2530
The original size is identified by the combination of presence and absence of output levels of
the reflection type sensors as summarized in the tables below.
- Absence of paper: The light reflected from the reflection type sensor changes when the
copyboard cover is open/close.
- Presence of paper: The light reflected from the reflection type sensor does not change when
the copyboard cover is open/close.
This machine is provided with the following sensors. Locations of the sensors are shown
below.
- Vertical scan direction: Reflection type photo sensors (2 locations for AB; 1 location for Inch)
- Horizontal scan direction: Reflection type photo sensors (2 locations for AB; 2 locations for
Inch)


CHECK YOUR CASSETTES SETUP
Double click on pics below
draw..JPG
draw1..JPG

[mrfixit51]

From what I can gather, he gets lines on copies from both the DADF and the glass,, sounds like a candidate for a new drum to me...

[darkmaster]

From what I can gather, he gets lines on copies from both the DADF and the glass,, sounds like a candidate for a new drum to me...

No. just use the ID copy have a middle black line.... another that all is normal.

[teckat]

No. just use the ID copy have a middle black line.... another that all is normal.

POST A PIC OF THE ISSUE !!!!!

Do u mean u get a black line in Book Mode ???

Explain ID COPY
ID COPY/ U Mean when u use the copy key( in red circle) or scan/options key (ir red circle)> Double click on picture/ sorry for bad pic

CONTROL..JPG


****Dirt Sensor Control
Overview
The machine changes the original read position or corrects the read image depending on the
presence/absence of dust on the stream reading glass or ADF platen
roller, thus preventing dust from showing up in the image. This control is performed only when
the ADF is used and it is closed.
[Control Timing]
- At job end
- Immediately before scanning (one sheet at a time)

[mrfixit51]

No. just use the ID copy have a middle black line.... another that all is normal.

Please explain to us what an ID copy, and IC copy is...