Afetr reciving files M2 imageruner restarts .what is the problem.
-
-
U mean the imagePass M2- what printer model is it on ??
Run a Hardware Diagnostic Mode on the imagePASS M1 / L1 /M2
1. Reboot the imagePASS M1 / L1 / M2.
2. When prompted with the 'Press any key for Config Mode' message, press any key.
3. The Config Mode menu will appear. Select Diagnostics. * This Diagnostic Mode will allow you to test all the hardware on the imagePASS M1 / L1 / M2.
Note: You can test the imagePASS M1 / L1 / M2's connection to the imageRUNNER by selecting Run Diagnostics from the idle menu (when the M1 / L1 / M2 is booted to idle). These diagnostic tests are very different from the Hardware Diagnostics Mode available in Config Mode.
U May have to re-load firmware on M2**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment