canon ir 2545

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • mazen
    Technician
    • Jan 2009
    • 54
    #1

    canon ir 2545

    Hi ....
    my problem whith finsher of canon 2545
    when i was installed a finesher in copier due to the installation manual and start on copier
    the copier dont know with finsher
    thanks for any one help me
    Tags: 2545, 545, canon, connections, control panel, copier, installation, installed, manual, sea, start, wrong
    • SCREWTAPE
      East Coast Imaging

      Site Contributor
      2,500+ Posts
      • Jan 2009
      • 3396
      #2
      Which finisher is it?

      Did you go over your connections?

      The finisher units come with instructions, all you have to do is follow.

        Comment

        • teckat
          Field Supervisor

          Site Contributor
          10,000+ Posts
          • Jan 2010
          • 16083
          #3
          Originally posted by mazen
          Hi ....
          my problem whith finsher of canon 2545
          when i was installed a finesher in copier due to the installation manual and start on copier
          the copier dont know with finsher
          thanks for any one help me

          U TALKING ABOUT INNER FINISHER B-1

          check PM
          **Knowledge is time consuming, exhausting and costly for a trained Tech.**

            Comment

            • charm5496
              Service Manager

              Site Contributor
              1,000+ Posts
              • Apr 2008
              • 2387
              #4
              It has to be the inner finisher B1, unless he has his model wrong.... check to see that you have the two connectors plugged in that are in the upper right hand corner of the machine just under the control panel.
              Accidents don't just happen. They must be carelessly planned.

                Comment

                • mrfixit51
                  Lead Service Technician

                  1,000+ Posts
                  • Oct 2008
                  • 1975
                  #5
                  Make sure copier is turned off when you add the finisher, and turn copier on after installation. The finisher should be recognized at that time. If not, some connector did not get seated.
                  "Once a King, always a King, but once a Knight is enough!"

                    Comment

                    • charm5496
                      Service Manager

                      Site Contributor
                      1,000+ Posts
                      • Apr 2008
                      • 2387
                      #6
                      Here are the installation instuctions
                      Attached Files
                      Accidents don't just happen. They must be carelessly planned.

                        Comment

                        Previous template Next
                        Working...