IRC2380 colours out of sync

[shazza]

Hi ,
RC2380 colours out of sync

Hi Guys, Ive got an IRC2380 out there where the colour registration keeps going out of sync. After adjusting up the colour registration for each colour it lasts for about a week and then goes out of sync again giving a sort of 3D effect.
Anyone had this fault or got any ideas.
Cheers guys....

Any Joy yet and find the cure? We have the same problem with a machine and Drum Drive assy,Itb,itb cleaner changed twice bt previous engineers.
Still comes back after about 30k
Cheers,

Shazza

[teckat]

Hi ,
RC2380 colours out of sync

Hi Guys, Ive got an IRC2380 out there where the colour registration keeps going out of sync. After adjusting up the colour registration for each colour it lasts for about a week and then goes out of sync again giving a sort of 3D effect.
Anyone had this fault or got any ideas.
Cheers guys....

Any Joy yet and find the cure? We have the same problem with a machine and Drum Drive assy,Itb,itb cleaner changed twice bt previous engineers.
Still comes back after about 30k
Cheers,

Shazza

see above>>>>>>>>>>>>>
Check the ITB / Drum Drive Assembly

[shazza]

hi Teket,


see above>>>>>>>>>>>>>
Check the ITB / Drum Drive Assembly


Both have been replaced twice and problem still exists

[teckat]

Hi Guys, Ive got an IRC2380 out there where the colour registration keeps going out of sync. After adjusting up the colour registration for each colour it lasts for about a week and then goes out of sync again giving a sort of 3D effect.
Anyone had this fault or got any ideas.
Cheers guys....

Remove the noise dampening pad for the Registration sensor flag and then performing Reg-Clear, Quick Adjust and then adjusting the IMG-REG
or
Try clearing out the Registration Data stored in the DC Controller. To clear the data, perform the following.

Enter Service Mode: Level 2 > Copier > Function > Clear > Reg/Clear. Highlight Reg/Clear and press OK.
After performing the clear, reboot the machine and perform a Gradation Quick Adjust and then a Full Gradation adjust.

Note*
Following the above instructions above could prevent you from having to perform a DC-CON clear, and inputting all DC-CON values from the door label.


do u have this on the 2380
Addition Functions > Adjustments and Cleaning > Auto Color Mismatch Correction