irad 5045 paper deck

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • roho
    Senior Tech

    500+ Posts
    • Mar 2009
    • 844
    #1

    [Jamming] irad 5045 paper deck

    Good day. A recent install with side paper deck has been getting 020f jams-pick up sensor in the paper deck, ps6d. I replaced the sep rollers due to a flat spot, but occasionally has been re-occurring. I haven't seen any tech pubs on this. I was wondering if anybody else has had some issues of this nature.
    Thanks in advance.
    Tags: deck, good, install, irad, jams, occurring, paper, pubs, sensor, side, spot, stall, tech
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16083
      #2
      Originally posted by roho
      Good day. A recent install with side paper deck has been getting 020f jams-pick up sensor in the paper deck, ps6d. I replaced the sep rollers due to a flat spot, but occasionally has been re-occurring. I haven't seen any tech pubs on this. I was wondering if anybody else has had some issues of this nature.
      Thanks in advance.

      did u install the DECK ?? or someone else ?

      a procedure needs to be followed !!
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • roho
          Senior Tech

          500+ Posts
          • Mar 2009
          • 844
          #3
          I installed it following the instructions. Possible something missed though.

            Comment

            • charm5496
              Service Manager

              Site Contributor
              1,000+ Posts
              • Apr 2008
              • 2387
              #4
              check the deck for level and make sure that the latches are holding correctly. Have had one where the entire feed head needed replacement.
              Accidents don't just happen. They must be carelessly planned.

                Comment

                • teckat
                  Field Supervisor

                  Site Contributor
                  10,000+ Posts
                  • Jan 2010
                  • 16083
                  #5
                  Originally posted by roho
                  I installed it following the instructions. Possible something missed though.


                  **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                    Comment

                    Previous template Next
                    Working...