If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
s1 Finisher on a 3570 alignment arm in the rear slaps the tray hard.
s1 Finisher on a 3570 alignment arm in the rear slaps the tray hard.
I have a finisher that actually outputs the paper ok but the paper alignment arms ( the three black arms ) slaps down so hard that the one in the back is wearing into the tray. Have you seen this before? The two in front are ok.
Comment