When I plug it in, machine cycles normally but no display, no response to any buttons and no fuser warmup. The only thing that works is the standby. Reseated panel and controller connectors. Customer probably getting rid of machine but I'd love to fix it.
-
-
Probably not worth the trouble if it is the main board. You can always check precision roller for cost.Accidents don't just happen. They must be carelessly planned. -
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
-
Customer scrapped it.Comment
-
AMEN~~~~~~~~~~~~~~~~~~;>}**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
that was a wise decision.Accidents don't just happen. They must be carelessly planned.Comment
Comment