[Error Code] Canon IRC3200N E020-04d0

[kahyik23]

I have change the blck developer

[charm5496]

could be the toner cartridge or the toner drive assembly. See below:

The Black toner feed motor was wired incorrectly causing the motor to operate in reverse. Toner would be augered away from the opening instead of toward it. The part number for the toner cartridge drive assembly is FG6-8999-000.
* The assembly is more cost effective than the motor.

[teckat]

I have change the blck developer

what do u mean u changed black developer ?

u mean u changed the Black Drum !!

make sure in pic below Drum tab/tabs are not damaged
E020.jpg


Best bet > call for service-request a Canon trained tech

[cnjcanon]

error code E020-04d0

This is what your error code is referring to and it is the black drum or toner that is affected.

The supply of toner for the toner
container to the developing assembly
has failed. The toner
cartridge motor fails to rotate.
The toner container is empty.
The toner supply mouth of the
drum unit is damaged. The ATR
sensor has an open circuit.
For the first 2 digits of detail
code xxEE,
xx=00: fault in access to drum
unit
xx=01: fault in access to toner
container

The fault occurs when an image is being
formed and, in addition, when the T/D ratio
drops while 20 prints are being made
continuously. It is detected when toner
supply operation is started.

Good luck and if all else fails call a Canon authorized tech