C1 imagepress color displacement

[mark921]

Just replaced the ITB on C1, along with the 2 trans roller, and now the yellow is off register, moving to the trail edge of the print. Just for for grins, i installed another ITB, but same issue. Hopefully, someone can guide me to a possible fix.

Cheers

[zoraldinho]

Just replaced the ITB on C1, along with the 2 trans roller, and now the yellow is off register, moving to the trail edge of the print. Just for for grins, i installed another ITB, but same issue. Hopefully, someone can guide me to a possible fix.

Cheers

Hi dude

Inspected by Canon Inc. ]

Description

Since the ITB connecting shaft was not tightened after the process unit to which a weight and the developing assembly were mounted was set into the main
body upon installation, yellow was displaced in both copying and printing. The degree of displacement worsen toward the trail edge.

Field Remedy

When the symptom occurs at test printing after re-mounting the process unit during installation or servicing, check to see if the ITB connecting shaft is
loosened; if so, tighten it again and then perform a copy/print job.
Note: When tightening the ITB connecting shaft [1], hold the drum fixing member [2] to prevent the idle rotation of the shaft.



ScreenShot004.jpg

[mark921]

Thanks!! Worked perfectly. MUCH appreciated!!!

[zoraldinho]

Thanks!! Worked perfectly. MUCH appreciated!!!

images24.jpg