ir 400 facedown feed out problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • etc
    Technician
    • Jul 2010
    • 17
    #1

    ir 400 facedown feed out problem

    i have a ir 400 that has a problem with face down feed out, whenever the m7 motor engages it is like the motor is running at 1/2 speed, causing 0131 jam codes.
    i have replaced the whole delivery door, the composite power supply the sub power supply the dc controller the ip board, any ideas? even during waqrmup when the m7 motor is energized it runs like it is getting 1/2 power, not slow just choppy thanks for any help
    Tags: codes, controller, dc controller, jam, motor, power, power supply, roller, slow, speed
    • zoraldinho
      teacher-guide-expert-guru

      Site Contributor
      5,000+ Posts
      • Mar 2008
      • 5007
      #2
      gp405-008.pdf

      I found only this pub talking about your jam code.Maybe can help.
      If it ain't broke, don't fix it
      A picture is worth a thousand words

        Comment

        • etc
          Technician
          • Jul 2010
          • 17
          #3
          YES I HAVE SEEN THAT, THE REAL ISSUE IS THE M7 REVERSAL MOTOR IS RUNNING AT 1/2 SPEED, LIKE IT IS MISSING 1/2 THE PULSE, resulting in the reverssal roller running at 1/2 speed, and that being choppy. i replaced everything i listed and still same issue. i am getting ready to start chasing being that i am runnibg out of ideas. the wiring diagram is pretty straight forward in that the signal comes straight from j-107 on the dcc through 2 connectors and into the m7 motor, the motor operates on a positive negative pulse because it runs in both directions, just need some ideas.

            Comment

            Previous template Next
            Working...