I am getting the error message E0061-003. Been on Canon's forum and found a few possibilities but no solution.
This code means the potential sensor has reached a higher than required voltage.
1. I change the potential pcb assembly, sensor and wires.
2. I check the drum for rotation as they say a screw can break on the drive gear in the back.
3. I made sure I had a good ground contact in the back on the HV1
One person mentioned that they turned of the v-con which stops the potential sensor from taking a reading.
I would like to try this but can't figure out how to turn it off.
Anybody have any ideas on this subject?
This code means the potential sensor has reached a higher than required voltage.
1. I change the potential pcb assembly, sensor and wires.
2. I check the drum for rotation as they say a screw can break on the drive gear in the back.
3. I made sure I had a good ground contact in the back on the HV1
One person mentioned that they turned of the v-con which stops the potential sensor from taking a reading.
I would like to try this but can't figure out how to turn it off.
Anybody have any ideas on this subject?
Comment