Canon 3220 Fuser Unit Disassembly. Help needed.

[NeonDoorMedia]

Im replacing the fuser unit roller, but can't figure out how to pop off a particular piece of the fuser unit. If someone can give me some tips I'd really appreciate it. It's the area that circled. Thanks

FUserUnit.jpg

[teckat]

FX-1.JPGFX-2.JPGFX-3.JPG

[NeonDoorMedia]

Once again THANKS Teckat! It was a bit tough to do, but I got it.

[teckat]

Thanks< don't forget to check the Nip Width/ in service mode when finished/
key up sorter & have it pulled away when testing


F20.JPGF21.JPG

[mrfixit51]

If someone can give me some tips I'd really appreciate it. It's the area that circled. Thanks

It was good of Teckat to provide you the procedure. You have to pry that roller guide off to access the front hinge pin. My quip was going to be, "pry on it till it almost breaks". That is not too far from the truth. I gave up trying to rebuild these, because that part or the entry guide invariably broke when I would try the disassembly.