If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It's related to the tempeture control of the fixing unit. You can only clear the error in service mode>fun>fuser>Eooo rls (I think), it's been a while working on that printer.
1) Start service mode, and select 'FUSER' under 'FUNC'.
2) Press 'E000 RLS'.
3) Turn off and then on the power switch. DC controller PCB has detected an overheating condition.
Replace thermistors on external heater.
If it ain't broke, don't fix it
A picture is worth a thousand words
Comment