To all you aces out there, I Have a irc 3080i with an intermittent E003-01 code. Replaced the fixing assembly,sw3,DC controller,main power supply RD upper and lower cap mod. to no avail. any ideas would be thoroughly appreciated!!!! Thanks.
-
-
Re: irc 3080i E003-01
How about the DC Driver PCB?
That's the one that takes signals from the thermistors...
also, I gotta ask: Customer Power?
-
Re: irc 3080i E003-01
Customers power checked out ok. I'll give the DC driver a try.Comment
-
Re: irc 3080i E003-01
CHECK THIS
SW3 is the Fixing unit's AC interlock switch. Sometimes the right door actuator will be bent and not fully press SW3 when the right door is closed. SW3 is a button switch located right above some of the Fixing unit's rear frame connections. SW3 has been found to show signs of wear and have carbon build up inside it. If the right door actuator is straight and making good contact , inspect SW3 and it's AC connections. If any flaws are found after inspecting SW3, replace it. SW3's part number is, FM2-9427-000
kb1017.jpg**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
-
Re: irc 3080i E003-01
Also an oddity I ran into last week could be a contributing factor. The upper bracket that is part of the right door hinge, the part near this actuator, was broken, and the door did not hang correctly. The steel had fractured, probably by the customer over extending the door when opening it. It had been jamming a lot. It was the kind of break you see from metal fatigue when something is flexed over and over till it breaks...
It is item #24"Once a King, always a King, but once a Knight is enough!"
Comment
-
Re: irc 3080i E003-01
Turned out to be a faulty rebuilt fixing assembly
. One of the those curve balls, thrown my way!!!
Comment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
Comment