First of all, I usually work on larger (50-105cpm) and color Canon's, so I'm not intimately familiar with these smaller ones. I have replaced drums and feed rollers, but no fuser work as of yet. I do have the manual.
I reset the code yesterday, recycled power a few times, ran copies and watched the temp in service mode - all seemed well. I did notice that the left side door was partially open at the bottom half of it when I arrived. I figured that may have caused the e-002.
Cust called back today with same code. The book says main thermistor.
Is this more likely a cust caused problem (left door not closed properly), a main thermistor, or possibly a fixing film problem?
**Edit - just noticed there is no thermistor listed in the fuser section of the 4570 or 3045 parts manuals. Anyone have a number?
I reset the code yesterday, recycled power a few times, ran copies and watched the temp in service mode - all seemed well. I did notice that the left side door was partially open at the bottom half of it when I arrived. I figured that may have caused the e-002.
Cust called back today with same code. The book says main thermistor.
Is this more likely a cust caused problem (left door not closed properly), a main thermistor, or possibly a fixing film problem?
**Edit - just noticed there is no thermistor listed in the fuser section of the 4570 or 3045 parts manuals. Anyone have a number?
Comment