[Jamming] ir 2870 jamming problem

[eng_migo]

i have a machine 2870 and it is jam paper between registration roller and the drum the paper look to be darpped from the middle
note: only the first paper jammed ..... and if the machine stop for a while and try to copy again it is also jammed the first paper

anyone have a solution for this problem

[Tricky]

Re: ir 2870 jamming problem

There's been quite a lot of updates to this machine

Is the registration sensor worn or does it have a metal edge?

Does the lower right door have a foam pad stuck to the top.

If the following parts are fitted the majority of jams in the right door are eliminated.


FM3-1297-000 RIGHT LOWER INNER DOOR ASSY

FM3-1296-000 RIGHT LOWER DOOR ASSEMBLY

FL2-4520-000 FLAG, PRE-REG SENSOR

[zoraldinho]

Re: ir 2870 jamming problem

Skynet is wright but Are you a tech?Jam code dude!!

[ikon01]

Re: ir 2870 jamming problem

The registration flag rests against a sponge pad to prevent noise,they do go sticky.This may be worth checking too.Guys are right aswell(a jam code helps)

[zoraldinho]

Re: ir 2870 jamming problem

The registration flag rests against a sponge pad to prevent noise,they do go sticky.This may be worth checking too.Guys are right aswell(a jam code helps)

DSC00004.jpg

[mrfixit51]

Re: ir 2870 jamming problem

The picture you show does not represent the sponge noise dampening pad that was referred to above. The steel plate that forms the registration area has the reg sensor flag mounted to the back of it. Remove the steel plate to get at the back of it where the flag actuates the sensor. That flag rests on the sponge pad, and they get gooey, and present with "morning sickness" symptoms. After the machine has set still for awhile, the sensor flag is firmly stuck to the pad and will jam the sheet in the registration area.

I just had to do this to an iRC3080 a couple of weeks ago, found it on my second visit, not the first...

[zoraldinho]

Re: ir 2870 jamming problem

jam.jpg

[eng_migo]

Re: ir 2870 jamming problem

The picture you show does not represent the sponge noise dampening pad that was referred to above. The steel plate that forms the registration area has the reg sensor flag mounted to the back of it. Remove the steel plate to get at the back of it where the flag actuates the sensor. That flag rests on the sponge pad, and they get gooey, and present with "morning sickness" symptoms. After the machine has set still for awhile, the sensor flag is firmly stuck to the pad and will jam the sheet in the registration area.

I just had to do this to an iRC3080 a couple of weeks ago, found it on my second visit, not the first...

thx very very thx for ur help it works with me

[mrfixit51]

Re: ir 2870 jamming problem

thx very very thx for ur help it works with me

You are welcome my friend,, I'm here to help when I can...