[Error Code] Canon ImagePress 6000VP Error Code 733 subcode 0000.

[Guest]

Good morning.

Know someone back Code E733-0000-00 on the installation.

This uppstog when I install a new machine and starts the machine and will initiate Pod and Stacker first time.

The machine will find the first non-Stacker and Pod. Then got up just Stacker on Pod was off, when I then try to find the pod it gives E code. I restart will return the error. I start with no current to the Pod is the machine up with Stacker.

To ensure Pod function, I tried to start the pod with 8 bit down on SW102 at Pod controller card to enter the adjustment mode. When the elevators and initiates Podcasts itself without contact with the machine.


Very grateful for help

[zoraldinho]

Re: Canon ImagePress 6000VP Error Code 733 subcode 0000.

Enter service mode and make settings for the connection order.
COPIER > OPTION > ACCPST-P
"Pod Deck 00100001" is displayed. => Input "1" and press "OK".

1. Be sure to turn off/on the power switch after setting the connection
sequence. If not, the accessory is not recognized.
2. At power on after setting the connection order, be sure not to set a paper
in the deck.
Only in the case that there is no paper in the deck at power on, implement
automatic 'Floatation Fan Air Flow Adjustment'.

Be sure to turn on the main power switch of the host machine after turning
on the power switch of the accessory.

When turning OFF the main power, both
the main unit and accessories must be
turned OFF. When turning the main
power back ON, turn the accessories ON
first, then the main unit.

In the case that the above display does not appear in service mode when
setting the connection sequence, check the following points.
1. The breaker [1] of the POD deck is turned on.
2. In the settings of NODE_ID switch [2], "1" is ON and "2 to 4" are OFF.

2. Check cable connection between DC controller PCB 1-3 and
main controller PCB (MAIN-P).

[kisavw]

Re: Canon ImagePress 6000VP Error Code 733 subcode 0000.

Thanks for the reply.


Enter service mode and make settings for the connection order.
COPIER > OPTION > ACCPST-P
"Pod Deck 00100001" is displayed. => Input "1" and press "OK". This is done.

1. Be sure to turn off/on the power switch after setting the connection
sequence. If not, the accessory is not recognized.
2. At power on after setting the connection order, be sure not to set a paper
in the deck.
Only in the case that there is no paper in the deck at power on, implement
automatic 'Floatation Fan Air Flow Adjustment'.

Be sure to turn on the main power switch of the host machine after turning
on the power switch of the accessory.

When turning OFF the main power, both
the main unit and accessories must be
turned OFF. When turning the main
power back ON, turn the accessories ON
first, then the main unit.

Up to this everything is correct by the Installation chapter.

In the case that the above display does not appear in service mode when
setting the connection sequence, check the following points.
1. The breaker [1] of the POD deck is turned on.
2. In the settings of NODE_ID switch [2], "1" is ON and "2 to 4" are OFF.

2. Check cable connection between DC controller PCB 1-3 and
main controller PCB (MAIN-P).

Have to chech the cables.