[CQ] iRC3380 , Repetitive Yellow Claw Marks along edges

[Victor285]

I am getting the following marks on the copies and print tests. Has anyone seen these or could point me in the right direction. The marks repeat along each side about 50mm apart (2 in.). Only happens when printing color and only Yellow. Could this be mag roller in Yellow drum? I appreciate all responses.

PG Test Images_C3380 001.jpgPG Test Images_C3380 002.jpg

Thanks,

Vic

[mjarbar]

Re: iRC3380 , Repetitive Yellow Claw Marks along edges

The fact it happens on the yellow only on your print samples would indicate the yellow drum is at fault, and would replace accordingly.

If you do a single colour test page or cingle colour copy on anything other than yellow do you still get marks?

[zoraldinho]

Re: iRC3380 , Repetitive Yellow Claw Marks along edges

Replace yellow cartrige.Inspect ITB (yellow transfer roller).Check drum life in service mode.Print PG-10 test.

[Victor285]

Re: iRC3380 , Repetitive Yellow Claw Marks along edges

Replace yellow cartrige.Inspect ITB (yellow transfer roller).Check drum life in service mode.Print PG-10 test.

Thanks for response. Customer is running partial staffing at time. Will check Tomorrow on Toner change and ITB. Drum Life, etc. Did run a PG10 test - Yellow. See attached, Thanks!

[teckat]

Re: iRC3380 , Repetitive Yellow Claw Marks along edges

pattern repeats are exactly the same image

YELLOW DRUM