Canon NP3825

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • GottaFixEmAll
    Technician

    50+ Posts
    • Jun 2007
    • 55
    #1

    Canon NP3825

    An old one for sure !!!, runs good ... message came up to change web, did that ... how does one re-set ??? I only have the Intavia guide on this one, it mentions a little hole to insert a hex key or paper clip into to push a service switch !! I've done this on other models - but could not find a hole anywhere in the control panel to do this !! ........... Any ideas ???

    Thanks, Mike
    Tags: canon, control panel, darker, np3825, off
    • barry1rose
      #2
      web counter reset

      hole under toner hopper bottom front right inside front panel.
      push pin into hole and $ will apper top left of display. then press *6* counter and scroll using i think the lighter and darker buttons till you find web counter . whilst pressing pin in hole press c button to zero .

      This is purely from memory and not seen one for about 10 years- hope this is correct............

      regards,

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 23008
          #3
          NP3825

          Enter service mode *6* > WEB 100002 > * > 0 > clear > reset > reset.

          This one is a little different than the other Canon's.
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • rajeshkumarind
              Technician
              • Feb 2008
              • 12
              #4
              Enter service mode *6* > WEB 100002 > * > 0 > clear > reset > reset.

              the main power swith off and on
              use service mode press *4* and use the light dark key go to ramint press * and press the main power of and on

                Comment

                • rajeshkumarind
                  Technician
                  • Feb 2008
                  • 12
                  #5
                  Enter service mode *6* > WEB 100002 > * > 0 > clear > reset > reset.

                  the main power swith off and on

                    Comment

                    Previous template Next
                    Working...