[CQ] CLC3220 +C1 mis-registration ploblem with the blade !!

[nochick]

Hi

I have mis-registration color with CLC3220 +c1

and after I try every thing follow the TP03 document

I clean ITB
change fixing unit
tranfer
change 4 drum units
switch the laser unit with other good machine
change ITB blade
clear D-con and MN-con**(this clear mode used to solve one of my irc3220 before. After try all of them)

and the result is on photo



[img=http://img39.imageshack.us/img39/127/bladed.th.jpg]

what should i do next??

THank you..

[nochick]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

anybody help me please

[teckat]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

anybody help me please

Tip-never this printer without a cleaning blade-

take the ITB unit and throw it in the Garbage

u need to do process of elimination for CQ issues
1-remove small panel right side to view ITB -
2-power off printer/ power on while looking at patches laid down on ITB-
3- are they off set ?
4- Now run a PG10> look at image on ITB> Are the colors off set ?


Check / Replace-External Secondary Transfer Assembly

DRUM DRIVE ASSEMBLY / also Drives ITB UNIT

[Canon.Tech]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

Also to add, you say you cleaned the ITB unit, you need to thoroughly clean INSIDE of the ITB belt & most importantly clean the large rubber drive rollers.

After fit the unit back & run a full auto gradation.

[nochick]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

Thank you teckat and Canon.Tech

from your advice So...
I switch from other good condition machine
1. ITB unit
2. hold unit from the left side fixing + tranfer
3. hold unit from the right side
4. 4 drum units

and fully adjust 3 times

ha ha ha It will be solve but

result is it's better for a few page and then it's back to the same problem

NOOOOOooooo!!!

Why!!??? motor and clutch register seem fine.

[Canon.Tech]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

Check the ITB drive ass'y the original gears were plastic & used to wear down causing your issue. They have been modified & now are made out of metal.

Take the drive gears from your working machine try that.

[nochick]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

Check the ITB drive ass'y the original gears were plastic & used to wear down causing your issue. They have been modified & now are made out of metal.

Take the drive gears from your working machine try that.

Thank you I will try...

[nochick]

Re: CLC3220 +C1 mis-registration ploblem with the blade !!

I just got modified gear unit from friend now i will try.....thank you Canon.Tech and teckat for advice ...