Machine threw code e100-001 took the laser and put it in a different machine to make sure the laser was bad and it coded out so i know the laser is bad, put a new laser in and still throws the code, repalced dc controller and still have the code,put the new laser in a different machine and it works fine .2 different dc controllers and still has the code , i might be missing something obvious, checked shutter and fan cover to see if the pin is broken shutter works fine,i know the laser i put in is good it works in another machine and the one that codes does it in another machine, any thoughts?
-
-
Re: ir 5055 e100-001
Did you check the door switches?
Did you check the DC Power Supply if 24v is all present?If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!Comment
-
Re: ir 5055 e100-001
Hello,
When working on machines, we sometimes cause new issues which are difficult to solve (they are not ordinary). There are three elements to be suspected: 1- Laser unit. 2- Dc contrller. 3- The connexion between the two. When you've pulled the laser connector, you might have created a loose connection. Try to replace the wirings.
Rachid."Find a job you love and you’ll never have to work a day in your life." Nagy's fatherComment
-
Re: ir 5055 e100-001
Check for proper voltage from DC power supply to DC Controller
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
Comment