iR ADV C9065 Drum LF didnt reset

[randall]

Hi everyone,

I was replacing drums on a ir adv c9065 last week and noted the LF counter didnt reset. I did follow the proper procedure turning AINR-OFF to 1(disabled) cycled power ran DRMRSET-C completed OK. enabled AINR-OFF to 0 cycled power ran proper user level adjustments. (also ran adj for releasing tension of ITB).. when everything was done I went back to service mode just to check the counters and noted that it had not reset to 0 and still showed old count of 213(yes i know this is high but if CQ hasn't suffered why change earlier)

Food for thought:
CQ is great so drum is performing as it should, just don't want any call backs or to damage machine.

Questions:
Has anyone seen this before?
Did I miss something?
why didn't fuse pop/counter reset?
is this indicative of something I should be aware of? i.e. bad drum that should be replaced

Thanks in ADV,
-R

[vigour]

Re: iR ADV C9065 Drum LF didnt reset

What you did should work. not sure why it did not for you
It worked for me at my last call
You might have to zero it manually.

I always used D-UNIT ymck
Now PT-DRY ymck is being used with the latest firmware.
if you zero PT-DRY (ymck) then LF will be zeroed at the same time.
I Never looked at LF till recently.

If your firmware is below a certain level the colour drum counts are incorrectly high. It would increment even if you ran black only.