imagerunner 2318 stackbypass issue

[montana]

hi everybody..i have an issue with canon imagerunner 2318 stack bypass the inner tray does not lift up to to feed the paper and make alittle noise it sounds like the gears are not engaged to move properly..any solution gentlemen???thanks

[edward robby]

Re: imagerunner 2318 stackbypass issue

i think thers a solenoid that not functioning , or needs a modification.

[montana]

Re: imagerunner 2318 stackbypass issue

i think thers a solenoid that not functioning , or needs a modification.

hi..thank you edward...i think the solenoid is working ..but how to modify it?
thanks again

[canonbundy]

Re: imagerunner 2318 stackbypass issue

hi everybody..i have an issue with canon imagerunner 2318 stack bypass the inner tray does not lift up to to feed the paper and make alittle noise it sounds like the gears are not engaged to move properly..any solution gentlemen???thanks

Did this problem start after replacing the Fixing Film Assy? If so, check the connector INSIDE the door, a common thing that happens when removing the L/H door is the connector with the Purple wires has not been disconnected from the Frame and the force of removing the door may partially disconnect the connector inside the door, which may also cause the machine to display 1 to 2 Sided copying ONLY.

[arielcanon]

Re: imagerunner 2318 stackbypass issue

increase spring tension of SPRING TORSION no 37.., to increase force, so that the gear will be engaged correctly.

[edward robby]

Re: imagerunner 2318 stackbypass issue

[just remove the foam and replace with any hard sticker, with atleast 2mm. of clearance when you close the metal plate. sometimes thats the real caause, yes. the solenoid is working but i think its intermitent. the activation is not constant.. like timing error , because of sticky old foam. :-D