Canon IR105 E004 0001

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • otomatic
    Technician
    • Jun 2009
    • 26
    #1

    Canon IR105 E004 0001

    hello all

    our ir105 has started the day throwing codes
    the first one was 010 and did the troubleshooting in the manual only to have it now do a e000 then cleared it and now it's doing e004-0001

    the manual has no indication of what the 0001 part is and suggests replacing the AC driver board and if that didn't work replace the DC controller

    is there anything else I could check to find the actual problem before we take that expensive fishing trip

    thanks
    Mike
    Tags: None
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16083
      #2
      Re: Canon IR105 E004 0001

      Originally posted by otomatic
      hello all

      our ir105 has started the day throwing codes
      the first one was 010 and did the troubleshooting in the manual only to have it now do a e000 then cleared it and now it's doing e004-0001

      the manual has no indication of what the 0001 part is and suggests replacing the AC driver board and if that didn't work replace the DC controller

      is there anything else I could check to find the actual problem before we take that expensive fishing trip

      thanks
      Mike

      E004-0001

      It may be necessary to replace the AC Driver PCB.

      The SSR is incorporated into the AC Driver (Part Number FG6-7264-000).


      did u check the heater lamp for damage
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • otomatic
          Technician
          • Jun 2009
          • 26
          #3
          Re: Canon IR105 E004 0001

          Originally posted by teckat

          E004-0001

          It may be necessary to replace the AC Driver PCB.

          The SSR is incorporated into the AC Driver (Part Number FG6-7264-000).


          did u check the heater lamp for damage
          is the SSR the relay on that board? if so iv'e checked those out and they seem to be working
          they both (AC board, DC board) click on then off at start up then the code after that

          I didn't check the lamps yet....

            Comment

            • otomatic
              Technician
              • Jun 2009
              • 26
              #4
              Re: Canon IR105 E004 0001

              I've checked the lamps and they are ok
              checked wiring from the AC board to the lamps and ok
              but the ground was open...traced it to the thermal protector and it was open

              new one on the way
              thanks

                Comment

                Previous template Next
                Working...