Can I remove an imagepass j1 option from a 3080 and put it in a 3080i ?

[Simons]

Transfer Open interface board would be the main thing I would think. I understand the PCL would then not function. Just needing to FOR SURE that I can transfer to the i model without issue. I have some info that says yes but I would rather hear from someone who has proof.

thanks!

[Tricky]

Re: Can I remove an imagepass j1 option from a 3080 and put it in a 3080i ?

Yes you can just change img-cont to 3 on the one that will have the fiery fitted and change it back to zero on the 3080.

[Simons]

Re: Can I remove an imagepass j1 option from a 3080 and put it in a 3080i ?

Great to hear that I can transfer the Open interface board keep the advanced feature set of U send.

[teckat]

Re: Can I remove an imagepass j1 option from a 3080 and put it in a 3080i ?

Transfer Open interface board would be the main thing I would think. I understand the PCL would then not function. Just needing to FOR SURE that I can transfer to the i model without issue. I have some info that says yes but I would rather hear from someone who has proof.

thanks!

Before Starting the Work

set '3': in COPIER>OPTION>INTFACE> IMG-CONT. (This way, the appropriate IP
address will automatically be setup for communication between the machine and its host machine.)

read---------------J1_Installation.pdf


firmware on 3080i must be MN-Cont 75.58 or later

COLOUR UFR II/PCL
PRINTER KIT-Q3 is already (Standard for i models)
PDL PCL5c, PCL6, UFR II

COLOUR UNIVERSAL
SEND KIT-N1 (Standard for i models)

COLOUR PS PRINTER KIT-Q3 (Optional for i models)

-----------------------------------------------------------------------------------
imagePass J1 V1.1
PDL Adobe PostScript 3, PCL 5c, PCL6