IR6570 E0010 AND 0002

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • digicor
    Service Manager

    1,000+ Posts
    • Jul 2008
    • 1150
    #1

    IR6570 E0010 AND 0002

    I HAVE RESET THE ERROR E0010 AND IT COMES RIGHT BACK,
    The power has been turned off and then onwithout resetting the error.
    THE MACHINE TURNS ITSELF OFF BEFORE I CN GET TO THE SERVICE MODE, OR I GET TO SERVICE MODE AND WHILE IN SERVICE MODE IT SHUTS OFF,
    OR I GET TO FUNC,CLER ERROR AND HIT OK AND THEN IT SHUTS ITSELF OFF,
    BY OFF I MEAN I HASVE TO RE START IT FROM THE PANEL NOT THE MAIN SWITCH, STILL, I GOT TO A 0002 CODE,
    The reading of the main thermistor, shutter thermistor, or sub thermistor is 230 deg Cor higher for 2 sec.
    TRIED TO CELAR THIS AND GOT THE 0010 CODE AGAIN,
    DC CONTROLLER BAD?
    Tags: None
    • Hitesh_honey
      Technician
      • Aug 2011
      • 19
      #2
      Re: IR6570 E0010 AND 0002

      dear
      e0010 error that men some unit rotating jam so main motor loaded and error came.

      main switch trip that mean main power grounded so trip check it.

      and temp going high first of all clean thermister both and resat machine

        Comment

        • HP:guy
          Trusted Tech

          250+ Posts
          • Feb 2013
          • 279
          #3
          Re: IR6570 E0010 AND 0002

          Open the front door then turn on the machine, it will finish power up and you should be able to get into service mode to clear.

            Comment

            • teckat
              Field Supervisor

              Site Contributor
              10,000+ Posts
              • Jan 2010
              • 16083
              #4
              Re: IR6570 E0010 AND 0002

              Originally posted by digicor
              I HAVE RESET THE ERROR E0010 AND IT COMES RIGHT BACK,
              The power has been turned off and then onwithout resetting the error.
              THE MACHINE TURNS ITSELF OFF BEFORE I CN GET TO THE SERVICE MODE, OR I GET TO SERVICE MODE AND WHILE IN SERVICE MODE IT SHUTS OFF,
              OR I GET TO FUNC,CLER ERROR AND HIT OK AND THEN IT SHUTS ITSELF OFF,
              BY OFF I MEAN I HASVE TO RE START IT FROM THE PANEL NOT THE MAIN SWITCH, STILL, I GOT TO A 0002 CODE,
              The reading of the main thermistor, shutter thermistor, or sub thermistor is 230 deg Cor higher for 2 sec.
              TRIED TO CELAR THIS AND GOT THE 0010 CODE AGAIN,
              DC CONTROLLER BAD?
              ================================================
              check for any stuck keys on panel / make sure they return when pushed ---

              The actuator for the fixing inlet sensor PS51 can break or become sluggish and cause an error code E001

              are your codes E001 & E002

              Replacing the Holder Unit ,may resolve the intermittent error codes. Part number FM2-3012-010. The Holder Unit is item 37 circled below.
              **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                Comment

                Previous template Next
                Working...