[Dead] Laser Unit IR5075

[satitjangdee]

My machine IR5075 shows code E0100-001 and cannot work anymore.
I try to find the spare part in my location but no one has.
Can I replace only BD board of other model?

Thank you.

[canonbundy]

Re: Laser Unit IR5075

My machine IR5075 shows code E0100-001 and cannot work anymore.
I try to find the spare part in my location but no one has.
Can I replace only BD board of other model?

Thank you.

Most times an E100 can be fixed by replacing the Fan Cover/Unit located above the Fixing assy, the plastic screw lug which holds the Fan Unit Cover in place breaks therefore the plastic Pin/Shaft on the Fan Cover does not have enough pressure to open the Laser Shutter which in turn will not allow the BD Signal to be detected - do not replace the BD PCD ........but the Fan Cover only.

[satitjangdee]

Re: Laser Unit IR5075

Most times an E100 can be fixed by replacing the Fan Cover/Unit located above the Fixing assy, the plastic screw lug which holds the Fan Unit Cover in place breaks therefore the plastic Pin/Shaft on the Fan Cover does not have enough pressure to open the Laser Shutter which in turn will not allow the BD Signal to be detected - do not replace the BD PCD ........but the Fan Cover only.

I had check the plastic peg of the Fan cover, it OK and I used screw driver push in this hole to open shutter laser unit to make sure enough pressure.
But it still error E0100-001

Thank you for your advice.
I have checked Laser Unit in another machine, it faulted.
I cannot find the spare part box set so I try to find the board.

[teckat]

Re: Laser Unit IR5075

I had check the plastic peg of the Fan cover, it OK and I used screw driver push in this hole to open shutter laser unit to make sure enough pressure.
But it still error E0100-001

Thank you for your advice.
I have checked Laser Unit in another machine, it faulted.
I cannot find the spare part box set so I try to find the board.

BD PCB= there is no part #