iR 3045 Finisher

[lionex3d]

what is the procedure for RAM initialization for the iR 3045 finisher. Thanks

[Brian8506]

Re: iR 3045 Finisher

What trouble are you having?

[lionex3d]

Re: iR 3045 Finisher

actually it's just for information
I was doing a iRC2880i Finisher-Z1
while reading the service manual, found that the controller PCB can be ram initialized
so I was wondering if the 3035/45 series finisher can also be ram initialized.

[its_just_a_copier]

Re: iR 3045 Finisher

actually it's just for information
I was doing a iRC2880i Finisher-Z1
while reading the service manual, found that the controller PCB can be ram initialized
so I was wondering if the 3035/45 series finisher can also be ram initialized.

Error :
For various error codes and malfunctions. If you suspect that the Finisher Controller PCB may need to be replaced, try the following to reset and clear the memory of the Finisher Controller PCB .

Workaround :
With the copier "ON' turn ON all 4 dip switches, cheat the finisher door switch, press and hold SW2 until the LED stops flashing. Then turn off copier, turn off dip switches and turn copier back on. Check to see if the finisher initializes and if the problem is resolved.