[CQ] irc2550 - half yellow missing on autograd

[Starion]

Hey,
anyone seen this before?
part of the yellow is missing on autograd pages. But otherwise fine. Pg10's etc are perfect.

Complete process drawer has been replaced, main controller, laser unit.
Firmware has been over written with latest.rcon clear, dccon clear etc done.

Ideas?

[Starion]

Hard to see BUT the yellow doesnt seem to be going down in gradations either.

[nochick]

Re: irc2550 - half yellow missing on autograd

I never seen thing like that before

but if it's okay when u print some real photo or something then what's the problem?

[northernlife]

Re: irc2550 - half yellow missing on autograd

old drum, dirty laser or faulty transfer in the IT (spring loaded). Personally I would clean the laser extremely well, pull the process unit out and clean it by hand with the wand applying downwards pressure. Check the drum life as well if it's 90% or over chances are it's failing.

[Starion]

Have swapped the laser from another machine. And also the entire process drawer, so all drums, itb, etc.

[teckat]

Re: irc2550 - half yellow missing on autograd

Have swapped the laser from another machine. And also the entire process drawer, so all drums, itb, etc.

how is the PG10 T PRINT looking ?

Swap the upper and lower PDRM-EF-A pcb's on the main controller and see if the issue moves to cyan instead of yellow.

if it does / replace the failed PDRM-EF-A PCB

[Starion]

Pg10 and sky shots work fine.

Will try swap the boards. Never really knew what they did, have never caused issues.

[teckat]

Re: irc2550 - half yellow missing on autograd

Pg10 and sky shots work fine.

Will try swap the boards. Never really knew what they did, have never caused issues.

-____-
PG10 looks good \
forget about skyshots , this is not a NP printer

test thosse pcb's

[Starion]

Perfect. Replaced that board and all fine. Thanks

[teckat]

Re: irc2550 - half yellow missing on autograd

Perfect. Replaced that board and all fine. Thanks

COLOR HAND.jpg