how to fix sticking for canon ir2318L when staring up?
plscanonir2318L.jpg
plscanonir2318L.jpg
-
-
Re: how to fix sticking start up for canon ir2318L
=======================
Blue Screen of Death
bad DDR Module
bad Image Processor
Procedure after Replacing the Image Processor PCB
If you have replaced the image processor PCB with a new one, perform the
following operations:
- Using the user support tool, download the latest firmware (System/Boot).
- Input the all value printed on the service label affixed to the rear cover.
Make the following adjustments:
- Correction of output between CIS channels
1) Enter the service mode.
Sequentially press the Additional Functions, # key on the operation panel.
2) Using the upper/lower arrow keys on the operation panel, select "Test".
3) Press the OK key.
4) Using the upper/lower arrow keys on the operation panel, select "Scanner
test".
5) Press the OK key.
6) Using the upper/lower arrow keys on the operation panel, select "CS Output
Test".
7) Press the OK key.
8) Select "Yes" and then press the OK key.
After completion of the above steps, contact sensor output correction will be
performed and parameters will be set automatically.
- Read position adjustment (Stream reading: Only when the ADF is installed)
1) Enter the service mode.
Sequentially press the Additional Functions, # key on the operation panel.
2) Using the upper/lower arrow keys on the operation panel, select "Test".
3) Press the OK key.
4) Using the upper/lower arrow keys on the operation panel, select "Scanner
test".
5) Press the OK key.
6) Using the upper/lower arrow keys on the operation panel, select "CS Position
Test".
7) Press the OK key.
8) Select "Yes" and press the OK key.
The optical system starts scanning. Several seconds later, automatic adjustment
of the reading position finishes and "OK" appears.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: how to fix sticking start up for canon ir2318L
how to download the user support tool,latest firmware (System/Boot)?Comment
Comment