[Misc] CANON IR5075 - Toner Supply Problem

[zelotprotos]

Dear All,

I have problem with Canon IR 5075 toner supply mechanism.

Here I attach an image.


ir5075 m9.jpg
All gears as shown by the red arrow doesn't rotate.

I have make sure that the hopper stirring motor (I am not sure of this motor's name ) is working (by trying it on other running machine)

There is no error at all and the machine works normally except that gears that doesn't rotate.

what may caused this problem occurs? which parts should I check? thank you

[laitang]

Re: CANON IR5075 - Toner Supply Problem

Check the toner sensor in front of developing assembly

iR-5075_Toner_sensor.JPG

[zelotprotos]

Re: CANON IR5075 - Toner Supply Problem

Check the toner sensor in front of developing assembly

[ATTACH=CONFIG]26915[/ATTACH]

no problem with toner sensor.

I have already try it on other machine (DEVELOPING UNIT)

[laitang]

Re: CANON IR5075 - Toner Supply Problem

iR-5075_Toner_Controller.JPG
- Check toner sensor TS1 and harness
- Check Motor M9 and harness : COPIER > FUNCTION > PART-CHK > MTR-ON
- Check DC-CON

[zelotprotos]

Re: CANON IR5075 - Toner Supply Problem

[ATTACH=CONFIG]26919[/ATTACH]
- Check toner sensor TS1 and harness
- Check Motor M9 and harness : COPIER > FUNCTION > PART-CHK > MTR-ON
- Check DC-CON

DSC_0394.JPGI have tried this unit to another running machine and the it works perfectly.

In which part the sensor is attached? if it is attached in this unit then the sensor has no problem.

could it be caused by the cable ? (as the M10 motor is working )
thank you.

[vigour]

Re: CANON IR5075 - Toner Supply Problem

Dear All,


All gears as shown by the red arrow doesn't rotate.

I have make sure that the hopper stirring motor (I am not sure of this motor's name ) is working (by trying it on other running machine)

There is no error at all and the machine works normally except that gears that doesn't rotate.

u

These gears rotate only when the developer needs toner from the sub-hopper.
If you want to test M10
go to service mode > Copier> Function> Part-CHK> MTR and enter 22
Then Press MTR-ON and watch the gears

[nochick]

Re: CANON IR5075 - Toner Supply Problem

I find Your problem in many machine and solution is that motor U got the red arrow on that one

There are 2 motors
1. Duty Rotate Gear to pump toner in develop this one is problem!!!
2. Duty just rotate cartridge never see this one broke

U can use motor from NP 6050 or IR 6570

Hope this help

[misserable old git]

Re: CANON IR5075 - Toner Supply Problem

Hi I have had this problem a couple of times before.
The gearing that rotates the toner bottle becomes stiff and puts excess load on the motor, and as a result eventually causes the driver circuit on the DC controller to fail.
check for dropped toner on the drive gears, and then replace DC controller.
good luck

[vigour]

Re: CANON IR5075 - Toner Supply Problem

the man said :
Gears turn when hopper is switched to another machine, plus his original machine has no other problem.
I take it that it copies fine, and he just likes to watch with gears

When that motor blows, it produces e025
Fortunately, I have never seen one e025 with dirty gears