Canon IR Adv C5030 Error E00002703-00

[canon33]

Re: Canon IR Adv C5030 Error E00002703-00

Here's a couple parts to get u started.

Fm4-8409-- itb improvement (comes with instructions) about 30 min install time. Can't hurt to put this in even if serial number range is out.

Qty2- fl3-1109-- bearings for the end of the inner xfer. roller. The roller is included in the above kit but not the bearings.

If u get there tmrrw and the plastic holDer that keeps pressure on the steering roller is broke then u need a new assy. ( no fixing that) If a plastic piece falls out of assy when u flip it then u know it's broke!!

Good luck and remember to run itb init after u think u fixed it.

[Canon345]

Re: Canon IR Adv C5030 Error E00002703-00

IMG_20141028_171107.jpgif you send me a pic of this label on the ITB I can tell you if the itb needs a kit or needs replaced. I need machine seriel number too. Or PM me for the information.

Canon33 - Plastic holder on the steer roller? You mean the white roller bushings?

[canon33]

Re: Canon IR Adv C5030 Error E00002703-00

[ATTACH=CONFIG]27172[/ATTACH]if you send me a pic of this label on the ITB I can tell you if the itb needs a kit or needs replaced. I need machine seriel number too. Or PM me for the information.

Canon33 - Plastic holder on the steer roller? You mean the white roller bushings?

I'm talking about the piece of plastic that is part of the free that the torsion spring is compressed onto. It is the piece that holds the new springs that come in the mod kit. Not sure how else to explain it. Sorry.

[Mark in England]

Re: Canon IR Adv C5030 Error E00002703-00

[ATTACH=CONFIG]27172[/ATTACH]if you send me a pic of this label on the ITB I can tell you if the itb needs a kit or needs replaced. I need machine seriel number too. Or PM me for the information.

Canon33 - Plastic holder on the steer roller? You mean the white roller bushings?

Hi,

Went there today - I think the belt wasn't under the guide so moving it and running the ITB INIT helped.

Here are the serial numbers etc so if you could send me the mod list/instructions it'd be really helpful to have to hand if I go out on another one for them.

Many many thanks

Mark

Trans Bed.jpgSerial of MC.jpg

[Canon345]

Re: Canon IR Adv C5030 Error E00002703-00

Your machine serial is not on the tech pub because you have a non USA machine. That's OK though, you can use the itb number to find out of you need a kit or whole new ITB. The info says your 15000000 range ITB needs a KIT. The 13000000 Part needs a new style ITB FM4-8412. I will mail you the info. Good Luck!

[fchu5959]

Re: Canon IR Adv C5030 Error E00002703-00

this thread has been dead for 7 years

+1

i still got 4-5 of these c50xx series in the field .almost 10 years old with more than 1.4 million copies on 1 or 2 machines and still going strong!!