Canon imageclass mf6550/ e197 error code

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • cucuklotz
    replied
    Re: Canon imageclass mf6550/ e197 error code

    Hi. I appreciate the help,I will let you know how it turns out. Andy

    Leave a comment:


  • niyaskarimba
    replied
    Re: Canon imageclass mf6550/ e197 error code

    Originally posted by Brian8506
    This is a desktop machine that uses plug in connectors
    Remove and re insert the fixing unit,only fixing unit connector problem

    Leave a comment:


  • Brian8506
    replied
    Re: Canon imageclass mf6550/ e197 error code

    This is a desktop machine that uses plug in connectors
    Originally posted by vigour
    What is your subcode i.e what four numbers or letters follow e197.
    It is different for different models.
    On this model , there is usually bad contact between the fixing frame connectors
    you could have a bent pin, or paper stuck in the connector.
    if you remove the finisher and left panels, you can watch to see of the connector is contacting the frame connector at an angle.
    Worse case, you may have to replace one or both connectors.

    Leave a comment:


  • ernesto
    replied
    Re: Canon imageclass mf6550/ e197 error code

    I had this problem once it was the fixing unit.... You can swap it to other machine....it is also said it could be the power supply.......
    All the best

    Leave a comment:


  • vigour
    replied
    Re: Canon imageclass mf6550/ e197 error code

    What is your subcode i.e what four numbers or letters follow e197.
    It is different for different models.
    On this model , there is usually bad contact between the fixing frame connectors
    you could have a bent pin, or paper stuck in the connector.
    if you remove the finisher and left panels, you can watch to see of the connector is contacting the frame connector at an angle.
    Worse case, you may have to replace one or both connectors.

    Leave a comment:


  • cucuklotz
    started a topic Canon imageclass mf6550/ e197 error code

    Canon imageclass mf6550/ e197 error code

    When I unplug machine for 5 minutes, the E197 message clears and machine says remove jam from side door area. I pull open and shut and machine resets. When I start copy again ,the E197 comes back. I have seen online much confusion as to what this code actually refers to .Does anyone know what actually causes this error code? THANKS ANDY
Working...