If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
After performing a MN CON clear on a Cannon IR4080 I noticed that the machine will not scan to file anymore I am wondering whether this turned off some function that needed to be activated. The customer was scanning before this was done.
After performing a MN CON clear on a Cannon IR4080 I noticed that the machine will not scan to file anymore I am wondering whether this turned off some function that needed to be activated. The customer was scanning before this was done.
it isn't recommended never to do MN CON or DC CON clear in that model
Comment