7272 "Please wait" dimly lit screen

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Downunder
    Trusted Tech

    100+ Posts
    • Aug 2007
    • 174

    #1

    7272 "Please wait" dimly lit screen

    7272 -- power on, relay comes on, screen very dark, no motors turning, just says "please wait" can hardly see the words on the screen. power save light on. When first turn on power timer light comes on for very short time then goes off then power save light stays on.

    Have tried, Main board, print control board, scan board, nvram

    Any help greatly appreciated.
  • Juggy
    Technical Support

    100+ Posts
    • Sep 2007
    • 101

    #2
    This might sound silly. If you have any IP 511A installed remove it from the copier and try switching on the machine. OR secondly swop the control panel assy

    Comment

    • Haroldbfix
      Trusted Tech

      100+ Posts
      • Feb 2008
      • 212

      #3
      Originally posted by Downunder
      7272 -- power on, relay comes on, screen very dark, no motors turning, just says "please wait" can hardly see the words on the screen. power save light on. When first turn on power timer light comes on for very short time then goes off then power save light stays on.

      Have tried, Main board, print control board, scan board, nvram

      Any help greatly appreciated.
      Will the machine take firmware? Also the IMCB can cause this.

      Comment

      • Downunder
        Trusted Tech

        100+ Posts
        • Aug 2007
        • 174

        #4
        replaced the operation panel complete unit, showed that there was a hrad drive issue. Some other faults arose as each one was rectified. ---- life as a copier tech... knew i should have done my school work!

        Comment

        Working...