Re: Bizhub C-360, 15-01 jams from the LCC (PC-408)...
Another cause is the paper not lifting high enough.
The paper then tends to hit the frame just below the mylar guide and delay the feed enough to cause a jam.
My solution is to saw off about 2 mm off the upper limit actuator so the tray lifts higher.
This has been a permanent solution on quite a few machines with this style of lcc.
Ps. I always use fine emery paper on the feed shafts every time I change rollers and have never had a problem with the shafts.
I have however had one ways slip when I've forgotten to do it!
Another cause is the paper not lifting high enough.
The paper then tends to hit the frame just below the mylar guide and delay the feed enough to cause a jam.
My solution is to saw off about 2 mm off the upper limit actuator so the tray lifts higher.
This has been a permanent solution on quite a few machines with this style of lcc.
Ps. I always use fine emery paper on the feed shafts every time I change rollers and have never had a problem with the shafts.
I have however had one ways slip when I've forgotten to do it!
Comment