C250 Fuser Codes

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • lanierboy
    Trusted Tech

    100+ Posts
    • Apr 2008
    • 149

    #1

    C250 Fuser Codes

    Hello Everyone

    I have a C250 that has a habit of showing fuser error codes.
    I have changed the fuser twice,power supply,main board and upgraded the firmware to 3.52 and still it trips out after about a month.

    the machine has been moved to another office and still plays up.
    anyone have this before?? also i see some people talking of using a line monitor to record mains behavour. recommended model??

    thank you
  • B0265
    Senior Tech

    500+ Posts
    • Jan 2007
    • 718

    #2
    I did get this tip, and it seems to have help in some cases:
    Change software switch 50 to HEX: 01.
    I'm sorry, but I don't have any information on what software switch 50 really is for.

    Comment

    • PaperCut
      Technician
      • Sep 2008
      • 21

      #3
      Check your LINE VOLTAGE, A good reading should be between 110 and 120 volts

      Comment

      • ni311
        Senior Tech

        Site Contributor
        500+ Posts
        • May 2008
        • 658

        #4
        By the way, does anyone have the list with the software switches for this machine? All I can found are the switches connected to CS Remote Care, nothing else...
        Konica Minolta Error Codes - Explanations and Solutions

        Comment

        Working...